E-MOBILITY · MERCEDES HOME CHARGING

Mercedes wallbox: charging the EQA and EQB at home

The Mercedes EQA 250+ and EQB 250+ charge at home on AC at 11 kW on three phases (3×16 A) as standard, which fills them from empty overnight. 22 kW needs two things at once: the optional 22 kW on-board charger in the car and a 3×32 A supply at the house. Any Type 2 wallbox does the job, not only the branded one. As an independent electrician we choose the charger for the car and the house supply, build the circuit and, if needed, handle the capacity increase. We are not an official Mercedes partner; we hand over the installation with protection tests and a test report.

How long does a Mercedes EQA or EQB take to charge at home?

On an 11 kW wall charger both the EQA 250+ and the EQB 250+ charge from 0 to 100 % in about 7 h 45 min. An EQA 250+ with the 22 kW on-board charger takes about 3 h 45 min on a 22 kW connection.

ModelMax. AC charging (standard)22 kW optionUsable battery0–100 % at 11 kW
EQA 250+11 kW (3×16 A)yes (needs 3×32 A)70.5 kWhapprox. 7 h 45 min
EQB 250+11 kW (3×16 A)yes (needs 3×32 A)70.5 kWhapprox. 7 h 45 min

Source: ev-database.org. In daily use you rarely charge from empty: after an average day’s driving the car tops up in a few hours, even at 11 kW.

When does a Mercedes charge at 22 kW?

Only when both conditions are met: the car has the optional 22 kW on-board charger, and the wall charger is supplied with 3×32 A. If either is missing, it charges at 11 kW.

  • Without the 22 kW on-board charger, even a 22 kW wallbox gives the EQA and EQB only 11 kW: the car limits the charging speed, not the charger.
  • On a 3×16 A connection, a car with the 22 kW on-board charger still charges at 11 kW, because three times 16 A delivers exactly that.
  • A 3×32 A supply needs a main fuse of at least 3×32 A at the meter, a heavier cable and a 32 A breaker; on a 3×16 A connection this means a capacity increase with the distribution operator.

Which on-board charger your car has is shown in the order equipment list, or the dealer can tell you. We ask about it during the survey, because it decides whether sizing for 22 kW makes sense. The 22 kW option works the same way on the Volvo EX30 and the Renault Mégane E-Tech.

Is a 22 kW connection worth it for a Mercedes?

For overnight charging at home, usually not. One night (8 hours) at 11 kW is about 88 kWh, more than the 70.5 kWh usable battery of the EQA and EQB, so the car is full by morning at 11 kW too.

22 kW is useful when the car already has the 22 kW on-board charger and you need to charge quickly during short daytime stops, or when the house already has a 3×32 A connection. Then a 22 kW wallbox on a 3×32 A circuit is a good choice; otherwise an 11 kW connection gives the same result by morning with less cable and paperwork.

Is the Mercedes wallbox worth buying?

It is not required: European Mercedes EQA and EQB models use a Type 2 connector for AC charging, so any Type 2 wall charger charges them as fast as the branded wallbox. The speed is set by the car’s on-board charger (11 or 22 kW), not by the brand of the charger.

If you choose the wallbox offered by the dealer, we install that too. If you choose another charger, look at these points rather than the brand: do you want solar charging, do you need a certified (MID) meter for the charged energy (for a company car, for example), will cars of other brands charge at the house, and do you need 11 or 22 kW. If there is a Tesla at the house too, our Tesla home charger page explains how the Wall Connector charges other brands.

Which wall charger should I choose for a Mercedes EQA or EQB?

For an 11 kW car an 11 kW (3×16 A) Type 2 wallbox; if the car has the 22 kW on-board charger and the house can supply 3×32 A, a 22 kW one. We source most brands through our wholesale partner Mile Kft., and Hager and Easee chargers through Voltus:

BrandModelNote
Schneider ElectricEVlink Home, EVlink Charge Prohome and “pro” versions
ABBTerra AC (W4–W22)the model code indicates the power, the W22 is 22 kW
BesenWallbox Smart 11/22 kWone of the most searched brands in Hungary
FroniusWattpilot Home 11/22 kWfor solar PV systems
TeslaWall Connector Gen 3up to 22 kW, charges other brands too if enabled
Hagerwittythrough Voltus
EaseeChargethrough Voltus

What does the house need for a Mercedes wall charger?

ElementWhy it is neededWhat we check
Three-phase supply11 kW needs 3×16 A, 22 kW needs 3×32 A; a single phase gives about 7.4 kW at mostnumber of phases and main fuse at the meter
Capacitythe charger draws close to full current for hours alongside the other loadsif it is not enough, we request an increase from the distribution operator (E.ON, MVM or Opus Titász)
Dedicated circuit and cablethe charger cannot share its circuitits own breaker; the cross-section depends on the current (16 or 32 A) and the length of the run
Residual current device (RCD)the car can cause DC fault currents that a standard type A RCD does not detecttype A-EV or B, depending on the charger’s built-in DC detection
Load managementthe oven or the heat pump may run while the car chargeswe set the charger’s current limit to the house
Solar chargingdaytime surplus goes into the car instead of the grida wallbox or control that follows the current PV output
Cable route and locationgarage, carport or fence; it has to work in rain and frostIP rating, cable routing, buried cable if needed

Rules and cost factors are described on our EV charger installation page; if the meter cabinet or the distribution board also needs replacing, see electrical installation. In a new house we plan the charger cable and the board space during electrical design.

How much does Mercedes charger installation cost, and is there a grant?

The price depends on the cable run, the condition of the distribution board, the 11 or 22 kW version and whether a capacity increase is needed. Typical price ranges are on our EV charger installation page; we give an exact quote after a site survey or from photos of the meter cabinet and the board, with the charger, the installation and the paperwork on separate lines. You can send photos via the details on our contact page.

There is no state grant for private home chargers in October 2026, and there has never been a dedicated programme: the E-AUTO-2021 residential scheme only supported buying the car.

How does a Mercedes charger installation work?

  1. 1
    Survey or photos

    We ask which model will charge and whether it has the 22 kW on-board charger, and check the meter (phases, main fuse), the distribution board and the cable route. In simpler cases, photos of the meter cabinet and the board are enough for a first quotation.

  2. 2
    Quotation and choice of charger

    11 or 22 kW wallbox, cable, protection, board extension and paperwork on separate lines.

  3. 3
    Paperwork

    If needed, notification or capacity increase with the distribution operator; the installation date then follows the utility’s procedure, which takes several weeks, sometimes a few months.

  4. 4
    Installation

    Dedicated circuit from the main board, sized cable, circuit breaker and a suitable RCD, mounting the charger. The installation itself is usually short.

  5. 5
    Commissioning and handover

    Setting the charger’s current limit for the car and the house, protection tests and test report, and a walk-through.

Frequently asked questions

Do you install a charger for a Mercedes bought from wallbox.hu or another web shop?

Yes. We install Type 2 wall chargers bought from wallbox.hu or any other web shop for a Mercedes too: we build the circuit, mount and commission the charger, and hand over the electrical safety test report. It is worth checking with us before you buy: a 22 kW charger only helps with the optional 22 kW on-board charger; otherwise 11 kW is enough.

How long does a Mercedes EQA take to charge at home?

The EQA 250+ charges from 0 to 100 % in about 7 h 45 min on an 11 kW wall charger; with the 22 kW on-board charger and a 3×32 A connection in about 3 h 45 min (ev-database.org).

Is the Mercedes wallbox worth buying?

It is not necessary: any Type 2 wall charger charges the EQA and EQB just as fast, because the speed is set by the car’s on-board charger. We also install the branded wallbox if you choose it.

Do I need a 22 kW charger for a Mercedes?

It only helps if the car has the optional 22 kW on-board charger and the house can supply 3×32 A. For overnight charging 11 kW is enough: about 88 kWh in 8 hours.

Is a 3×16 A connection enough for a Mercedes EQA?

Yes, for 11 kW charging, if the charger’s current limit is matched to the other loads in the house. 22 kW needs 3×32 A, which means a capacity increase.

Are you an official Mercedes partner?

No. As an independent electrician we install wall chargers for electric cars of any brand to the electrical standards, with protection tests and a test report.

Is there a grant for home chargers?

In October 2026 there is no open state grant for private home chargers; the E-AUTO-2021 residential scheme also only supported buying the car.

Let’s talk about your project.

Tell us what you are planning and we will get back to you within a few days.

Get in touch

Cookie settings

Choose what you consent to. We remember your choice for 6 months; change it any time via “Cookie settings” in the footer.

Privacy notice