BMW home charger: wallbox installation for family homes
To charge a BMW i4, iX1 or iX3 at home you need a three-phase wall charger on a dedicated circuit, at 3×16 A and 11 kW. The iX1 and the new iX3 can also be ordered with an optional 22 kW on-board charger: on a 3×32 A connection they then charge in about half the time, but the house supply has to handle it. As an independent electrician we install any Type 2 wallbox, build the circuit for it and, if needed, handle the capacity increase with the utility. We are not an official BMW partner; we hand over the installation with protection tests and a test report.
How long do the BMW i4, iX1 and iX3 take to charge at home?
As standard, each model charges on AC at 11 kW at most, on three phases (3×16 A). The iX1 and the new iX3 can also be ordered with an optional 22 kW on-board charger, which makes them about twice as fast on a 3×32 A connection.
| Model (version) | Max. AC charging | Phases × current | 22 kW option | Usable battery | 0–100 % at max. AC |
|---|---|---|---|---|---|
| BMW i4 eDrive40 | 11 kW | 3×16 A | no | 81.3 kWh | approx. 8 h 45 min |
| BMW iX1 eDrive20 | 11 kW (22 kW optional) | 3×16 A (3×32 A) | yes | 65.2 kWh | approx. 7 h (at 22 kW approx. 3 h 30 min) |
| BMW iX3 50 xDrive (2025–26) | 11 kW (22 kW optional) | 3×16 A (3×32 A) | yes | 108.7 kWh | approx. 11 h 45 min (at 22 kW approx. 6 h) |
| BMW iX3 (previous generation, 2021–2024) | 11 kW | 3×16 A | no | 74.0 kWh | approx. 8 h |
Source: ev-database.org. The new iX3’s battery is so large that an 8-hour night at 11 kW (about 88 kWh) does not fill it from empty; in daily use, however, you rarely charge from empty, and after an average day’s driving the car is topped up in a few hours.
Do I need a 22 kW wallbox for a BMW?
Only if the car has the 22 kW on-board charger. The i4 and the previous-generation iX3 charge at 11 kW at most, so a 22 kW connection does nothing for them. On the iX1 and the new iX3 it is optional equipment: whether your car has it is shown in the equipment list or by the dealer, and we ask about it during the survey.
Even if the car accepts 22 kW, it is worth weighing up: 11 kW still fills the iX1 overnight (about 7 hours). 22 kW mainly helps if the car stops at home only briefly during the day, or if the new iX3’s large battery often has to be charged from low.
What does the house need for 22 kW BMW charging?
22 kW charging draws 32 A per phase for hours, so the house has to supply considerably more than at 11 kW:
| Aspect | 11 kW (3×16 A) | 22 kW (3×32 A) |
|---|---|---|
| Breaker and cable | 16 A; typically 5×2.5 mm² on short runs, 5×4 mm² on longer ones | 32 A; thicker cable, sized for the length of the run |
| Main fuse at the meter | there must be capacity left for the other loads besides the 3×16 A charger | there must be capacity left for the other loads besides the 3×32 A charger; in most houses this means a capacity increase |
| iX1 eDrive20 0–100 % | approx. 7 h | approx. 3 h 30 min |
| iX3 50 xDrive 0–100 % | approx. 11 h 45 min | approx. 6 h |
A good middle way is often a charger that can do 22 kW, with the connection and current limit set for today’s supply; if the capacity is increased later, the charger can be reconfigured. For this we size the cable for the higher current from the start.
Can you charge a BMW from a normal socket?
Occasionally, with a portable charging cable, yes, but it is very slow: a Schuko socket at 10 A gives about 2.3 kW, which means more than a day from empty for a 65–80 kWh battery. As electricians we do not recommend it for regular charging: a standard socket and its wiring are not made for hours of near-full load, and the connection heats up over time.
If the car is always parked in the same place, a wall charger on a dedicated circuit is the safe and convenient solution: at 11 kW it adds about 60 km of range per hour (assuming 18 kWh/100 km).
Do I need a BMW-branded wallbox?
No. BMW also offers its own wall charger, but at home any Type 2 wallbox charges the car just as fast. BMWs sold in Europe use Type 2 for AC charging and CCS2 for DC fast charging; a home wall charger is AC, so it has a Type 2 connector.
The charging speed is limited by the car’s on-board charger (11 or 22 kW), not by the brand of the wallbox. If you have already bought BMW’s own charger, we install it; if you have not decided yet, we recommend a charger based on the house supply, the PV system and the number of cars.
Which wallbox should I choose for a BMW?
An 11 kW (3×16 A) charger for the i4 and the previous iX3, and a 22 kW-capable charger for an iX1 or new iX3 with the 22 kW on-board charger, if the house can supply it. We source most brands through our wholesale partner Mile Kft., and Hager and Easee chargers through Voltus:
| Brand | Model | Note |
|---|---|---|
| Schneider Electric | EVlink Home, EVlink Charge Pro | home and “pro” versions (Mile Kft.) |
| ABB | Terra AC (W4–W22) | the model code indicates the power, the W22 is 22 kW (Mile Kft.) |
| Besen | Wallbox Smart 11/22 kW | one of the most searched brands in Hungary (Mile Kft.) |
| Fronius | Wattpilot Home 11/22 kW | for solar PV systems (Mile Kft.) |
| Tesla | Wall Connector Gen 3 | up to 22 kW, charges other brands too if enabled (Mile Kft.) |
| Hager | witty | via Voltus |
| Easee | Charge | via Voltus |
If a car of another brand also charges at the house, see our pages on home charging for Volkswagen and Škoda, Hyundai and Kia or Tesla as well.
What does the house need for a BMW wallbox?
| Element | Why it is needed | What we check |
|---|---|---|
| Three-phase supply | 11 and 22 kW need three phases; one phase gives at most about 7.4 kW | number of phases and main fuse at the meter |
| Capacity | the charger draws 3×16 A (3×32 A at 22 kW) for hours alongside the other loads | if the contracted capacity is not enough, we request an increase from the distribution operator (E.ON, MVM or Opus Titász) |
| Dedicated circuit and cable | the charger cannot share its circuit | its own breaker; the cross-section depends on the current and the length of the run |
| Residual current device (RCD) | the car can cause DC fault currents that a standard type A RCD does not detect | type A-EV or B, depending on the charger’s built-in DC detection |
| Load management | the oven or the heat pump may run while the car charges | we set the charger’s current limit to the house |
| Solar charging | daytime surplus goes into the car instead of the grid | a wallbox or control that follows the current PV output |
| Cable route and location | garage, carport or fence; it has to work in rain and frost | IP rating, cable routing, buried cable if needed |
Rules and cost factors are described on our EV charger installation page; if the meter cabinet or the distribution board also needs replacing, see electrical installation. In a new house we plan the charger cable and the board space during electrical design.
How much does a BMW wallbox installation cost, and is there a grant?
Indicative prices are on our EV charger installation page. The exact price depends on the cable run, the condition of the distribution board and whether a capacity increase is needed (more common at 22 kW), so we quote after a site survey or from photos of the meter cabinet and the distribution board; the quotation lists the charger, the installation and the paperwork on separate lines. You can send photos via the details on our contact page.
There is no state grant for private home chargers in October 2026, and there has never been a dedicated programme: the E-AUTO-2021 residential scheme only supported buying the car.
How does a BMW charger installation work?
- 1Survey or photos
We ask which BMW will charge and whether it has the 22 kW on-board charger, then check the meter (phases, main fuse), the distribution board and the cable route. In simpler cases, photos of the meter cabinet and the board are enough for a first quotation.
- 2Quotation and choice of charger
11 or 22 kW wallbox, cable, protection, board extension and paperwork on separate lines.
- 3Paperwork
If needed, notification or capacity increase with the distribution operator; the installation date then follows the utility’s procedure, which takes several weeks, sometimes a few months.
- 4Installation
Dedicated circuit from the main board, sized cable, circuit breaker and a suitable RCD, mounting the charger. The installation itself is usually short.
- 5Commissioning and handover
Setting the charger’s current limit for the car and the house, protection tests and test report, and a walk-through.
Frequently asked questions
Do you install a charger for a BMW bought from wallbox.hu or another web shop?
Yes. We install Type 2 wall chargers bought from wallbox.hu or any other web shop for a BMW too: we build the circuit, mount and commission the charger, and hand over the electrical safety test report. It is worth checking with us before you buy: a 22 kW charger only helps an iX1 or new iX3 ordered with the 22 kW on-board charger; otherwise 11 kW is enough.
How long does a BMW i4 take to charge at home?
The i4 eDrive40 (81.3 kWh) charges from 0 to 100 % in about 8 hours 45 minutes on an 11 kW wall charger (ev-database.org).
Which charger does the BMW iX1 need?
As standard, an 11 kW three-phase (3×16 A) wall charger with a Type 2 connector; a full charge takes about 7 hours. If the iX1 has the optional 22 kW on-board charger, a 22 kW charger on a 3×32 A connection takes about 3 hours 30 minutes.
Do I need a 22 kW wallbox for a BMW i4?
No. The i4 charges on AC at 11 kW at most, for which a 3×16 A connection is enough; a 22 kW connection is not faster, only more expensive.
How long does the new BMW iX3 take to charge?
The iX3 50 xDrive (108.7 kWh) takes about 11 hours 45 minutes from 0 to 100 % at 11 kW, and about 6 hours with the optional 22 kW on-board charger on a 22 kW connection (ev-database.org).
Do I have to buy a BMW-branded wallbox?
No. Any Type 2 wall charger charges a BMW; the speed is set by the car’s on-board charger. If you have already bought BMW’s charger, we install that too.
Are you an official BMW partner?
No. As an independent electrician we install wall chargers for electric cars of any brand to the electrical standards, with protection tests and a test report.
Is there a grant for home chargers?
In October 2026 there is no open state grant for private home chargers; the E-AUTO-2021 residential scheme also only supported buying the car.
Let’s talk about your project.
Tell us what you are planning and we will get back to you within a few days.
Get in touch