E-MOBILITY · HYUNDAI AND KIA HOME CHARGING

Hyundai and Kia home charger: wallbox installation for family homes

To charge a Hyundai Kona Electric, Ioniq 5, Kia EV3, EV6 or Niro EV at home you need a three-phase wall charger on a dedicated circuit: at 3×16 A and 11 kW, these models charge from empty to full in about 7 to 8 hours 45 minutes, in other words overnight. As an independent electrician we install any Type 2 wallbox, build the circuit for it and, if needed, handle the capacity increase with the utility. We are not an official Hyundai or Kia partner; we hand over the installation with protection tests and a test report.

How long do the Kona Electric, Ioniq 5 and Kia EV6 take to charge at home?

Each model charges on AC at 11 kW at most, on three phases (3×16 A). The Kona Electric and the Niro EV take about 7 hours, the EV3 Long Range about 8 hours 30 minutes, and the 84 kWh Ioniq 5 and EV6 about 8 hours 45 minutes from 0 to 100 %.

Model (version)Max. AC chargingPhases × currentUsable battery0–100 % at 11 kW
Hyundai Kona Electric 65.4 kWh11 kW3×16 A65.4 kWhapprox. 7 h
Hyundai Ioniq 5 84 kWh RWD11 kW3×16 A80 kWhapprox. 8 h 45 min
Kia EV3 Long Range11 kW3×16 A78 kWhapprox. 8 h 30 min
Kia EV6 84 kWh RWD11 kW3×16 A80 kWhapprox. 8 h 45 min
Kia Niro EV 64.8 kWh11 kW3×16 A64.8 kWhapprox. 7 h

Source: ev-database.org. For versions with a smaller battery we check the on-board charger power from the car’s data during the survey. In daily use you rarely charge from empty: after an average day’s driving the car is topped up in a few hours.

Do I need a 22 kW charger for a Hyundai or Kia?

No. None of the models above accepts 22 kW on AC, and a 3×16 A connection delivers the 11 kW in full. A 22 kW (3×32 A) connection does not make these cars charge faster; it only needs a thicker cable, a larger breaker and often a capacity increase.

One night (8 hours) at 11 kW gives about 88 kWh, more than the full usable capacity of any of the models above.

Can you charge a Kona Electric from a normal socket?

Occasionally, with a portable charging cable, yes, but it is very slow: a Schuko socket at 10 A gives about 2.3 kW, which means more than a day from empty for a 65 kWh battery. As electricians we do not recommend it for regular charging: a standard socket and its wiring are not made for hours of near-full load, and the connection heats up over time.

If the car is always parked in the same place, a wall charger on a dedicated circuit is the safe and convenient solution: at 11 kW it adds about 60 km of range per hour (assuming 18 kWh/100 km).

Do I need a Hyundai- or Kia-branded wallbox?

No. The brand also offers its own wall charger, but at home any Type 2 wallbox charges the car just as fast. Hyundais and Kias sold in Europe use Type 2 for AC charging and CCS2 for DC fast charging; a home wall charger is AC, so it has a Type 2 connector.

The charging speed is limited by the car’s on-board charger (11 kW), not by the brand of the wallbox. If you have already bought the brand’s own charger, we install it; if you have not decided yet, we recommend a charger based on the house supply, the PV system and the number of cars.

Which wallbox should I choose for a Hyundai or Kia?

An 11 kW (3×16 A) wall charger with a Type 2 connector. We source most brands through our wholesale partner Mile Kft., and Hager and Easee chargers through Voltus:

BrandModelNote
Schneider ElectricEVlink Home, EVlink Charge Prohome and “pro” versions (Mile Kft.)
ABBTerra AC (W4–W22)the model code indicates the power (Mile Kft.)
BesenWallbox Smart 11/22 kWone of the most searched brands in Hungary (Mile Kft.)
FroniusWattpilot Home 11/22 kWfor solar PV systems (Mile Kft.)
TeslaWall Connector Gen 3charges other brands too if enabled (Mile Kft.)
Hagerwittyvia Voltus
EaseeChargevia Voltus

Can two electric cars charge at the same house?

Yes, but two 11 kW chargers running at once would draw 3×32 A, which a family home supply rarely handles alongside the other loads. There are two solutions: load balancing, where the two chargers share the available current (after an average day’s driving both cars are still topped up overnight), or a capacity increase with the distribution operator.

Which is cheaper depends on the meter, the daily mileage and the other large loads in the house (heat pump, hob); we calculate it during the survey. If the second car is another brand, see our pages on home charging for Volkswagen and Škoda, BMW or Tesla as well.

What does the house need for a Hyundai or Kia wallbox?

ElementWhy it is neededWhat we check
Three-phase supply11 kW needs three phases; one phase gives at most about 7.4 kWnumber of phases and main fuse at the meter
Capacitythe charger draws 3×16 A for hours alongside the other loadsif the contracted capacity is not enough, we request an increase from the distribution operator (E.ON, MVM or Opus Titász)
Dedicated circuit and cablethe charger cannot share its circuitits own breaker; at 11 kW typically 5×2.5 mm² on short runs, 5×4 mm² on longer ones
Residual current device (RCD)the car can cause DC fault currents that a standard type A RCD does not detecttype A-EV or B, depending on the charger’s built-in DC detection
Load managementon a 3×16 A supply 11 kW only fits if no other large load runs at the same timewe set the charger’s current limit to the house
Solar chargingdaytime surplus goes into the car instead of the grida wallbox or control that follows the current PV output
Cable route and locationgarage, carport or fence; it has to work in rain and frostIP rating, cable routing, buried cable if needed

Rules and cost factors are described on our EV charger installation page; if the meter cabinet or the distribution board also needs replacing, see electrical installation. In a new house we plan the charger cable and the board space during electrical design.

How much does a Hyundai or Kia wallbox installation cost, and is there a grant?

Indicative prices are on our EV charger installation page. The exact price depends on the cable run, the condition of the distribution board and whether a capacity increase is needed, so we quote after a site survey or from photos of the meter cabinet and the distribution board; the quotation lists the charger, the installation and the paperwork on separate lines. You can send photos via the details on our contact page.

There is no state grant for private home chargers in October 2026, and there has never been a dedicated programme: the E-AUTO-2021 residential scheme only supported buying the car.

How does a Hyundai or Kia charger installation work?

  1. 1
    Survey or photos

    We ask which model and battery version will charge (and whether there is a second car), and check the meter (phases, main fuse), the distribution board and the cable route. In simpler cases, photos of the meter cabinet and the board are enough for a first quotation.

  2. 2
    Quotation and choice of charger

    Wallbox, cable, protection, board extension and paperwork on separate lines.

  3. 3
    Paperwork

    If needed, notification or capacity increase with the distribution operator; the installation date then follows the utility’s procedure, which takes several weeks, sometimes a few months.

  4. 4
    Installation

    Dedicated circuit from the main board, sized cable, circuit breaker and a suitable RCD, mounting the charger. The installation itself is usually short.

  5. 5
    Commissioning and handover

    Setting the charger’s current limit for the house, protection tests and test report, and a walk-through.

Frequently asked questions

Do you install a charger for a Hyundai or Kia bought from wallbox.hu or another web shop?

Yes. We install Type 2 wall chargers bought from wallbox.hu or any other web shop for a Hyundai or Kia too: we build the circuit, mount and commission the charger, and hand over the electrical safety test report. It is worth checking with us before you buy: an 11 kW three-phase charger is the right choice for these cars.

How long does a Kona Electric take to charge at home?

The Kona Electric 65.4 kWh charges from 0 to 100 % in about 7 hours on an 11 kW wall charger (ev-database.org).

Which charger does the Kia EV6 need?

An 11 kW three-phase (3×16 A) wall charger with a Type 2 connector. The EV6 84 kWh RWD charges from empty to full on it in about 8 hours 45 minutes.

Do I need a 22 kW wallbox for a Hyundai or Kia?

No. The Kona Electric, Ioniq 5, EV3, EV6 and Niro EV charge on AC at 11 kW at most, for which a 3×16 A connection is enough. A 22 kW connection is not faster, only more expensive.

Do I have to buy the brand’s own wallbox?

No. Any Type 2 wall charger charges a Hyundai or Kia; the speed is set by the car’s on-board charger. If you have already bought the brand’s charger, we install that too.

Can two electric cars charge at one house?

Yes, with load balancing that shares the available current between the two chargers, or with a capacity increase. We work out the better option during the survey.

Are you an official Hyundai or Kia partner?

No. As an independent electrician we install wall chargers for electric cars of any brand to the electrical standards, with protection tests and a test report.

Is there a grant for home chargers?

In October 2026 there is no open state grant for private home chargers; the E-AUTO-2021 residential scheme also only supported buying the car.

Let’s talk about your project.

Tell us what you are planning and we will get back to you within a few days.

Get in touch

Cookie settings

Choose what you consent to. We remember your choice for 6 months; change it any time via “Cookie settings” in the footer.

Privacy notice